iam

Waterjet cutting, highest prestations

Ver vídeo

The waterjet Cutting allows us to cut any type of material.

  • Titanium
  • Stainless Steel
  • Steel
  • Aluminium
  • Copper
  • Brass
  • Bronze
  • Ferrite
  • Composites
  • Insulators
  • Glass
  • Fibres
  • Rubber
  • Methacrylate
  • P.V.C.
  • Polycarbonate
  • Marble
  • Granite
  • Ceramics
  • Polystyrene
  • Polymers
  • Wood
  • Polyethylene
  • Stratified
  • Invar
  • Inconel
  • Duretal
  • Duplex
  • Monel
  • Honeycomb
  • Corten Steel
  • Monolux
1 machine
6000 x 3000 x 200 mm with 2 cutting heads and dynamic cut, 4100 bar of pressure.
2 machines
4000 x 2000 x 200 mm with dynamic cut, 6000 bar of pressure.
1 machine
4000 x 2000 x 200 mm with 2 cutting heads and dynamic cut, 4100 bar of pressure.
1 department
Of quality service to obtain measurement reports.
  • Corte por chorro de agua

    Waterjet cutting process

    Water jet cutting is a mechanical process in which, by means of the impact of water at high pressure, all types of material are cut to the desired geometry. IAM CUT has 4 conventional water jet cutting machines.

    More information

Waterjet cutting

Advantages of the process

  • Cold cutting where properties remain unchanged.
  • Capable of cutting any material in thicknesses up to 200 mm.
  • Capable to produce very complex geometric shapes.
  • Does not create stresses in the finished part.
  • In several cases, the part extracted from the cut does not require any type of finishing.
  • Environmentally friendly process, as it does not emit gases or dust into the air.

Parts obtained